Home » CCNA

Switchport Modes | Trunk Port | Access Port

switchport-mode-access-and-trunk

In this article, we will discuss switchport and switchport modes. While working on Cisco platform switches, you may come across Trunk Mode and Access Mode. So, let’s start! What is Switchport Mode in Cisco Switches The term “Switchport”…

Read More »

Cisco line vty 0 – 4 Explanation and Configuration | VTY – Virtual Teletype

cisco-line-vty-0-4-configuration-and-explanation

In this article, we will discuss the meaning of the Cisco line vty command. While working on Cisco Router or Switch you may come across to the line vty configuration. So, this article will explain the “line vty…

Read More »

How to configure IPSec VPN Between Cisco ASA and Palo Alto Firewall

ipsec-tunnel-between-cisco-asa-and-paloalto-firewall

In this article, we will configure the IPSec Tunnel between Palo Alto and Cisco ASA Firewall. In this example, I’m using PANOS 8.1.10 on the Palo Alto firewall. Although, the configuration is almost the same in other PANOS…

Read More »

IPSec Tunnel between Cisco ASA Firewall and Cisco Router

ipsec-tunnel-between-cisco-asa-and-cisco-router

In this article, we will configure the IPSec tunnel between the Cisco ASA and Cisco Router. We will configure the Policy Based IPSec tunnel between both of them. You must have static routable IP addresses to establish the…

Read More »

IPSec Tunnel Between Cisco Routers | Site to Site VPN Between Cisco Routers

ipsec-tunnel-between-cisco-routers

In this article, we will discuss, how you can configure IPSec Tunnel between Cisco Routers at different locations. IPsec Tunnel allows you to communicate securely to the remote office over the Internet. All the traffic through the IPSec…

Read More »

How to configure GRE Tunnel between Cisco Routers

how-to-create-gre-tunnel-between-cisco-routers

In this article, we will configure the GRE (Generic Routing Encapsulation) tunnel between two Cisco Routers. GRE is developed by Cisco System. In order to configure the GRE tunnel, you must need connectivity between two remote routers through…

Read More »

How to connect GNS3 Appliances to Internet

how-to-connect-gns3-to-internet

In this article, we will discuss how we can connect our GNS3 appliances with the internet. Many times, we want to communicate our virtual appliances to communicate with the Internet. You can also connect your virtual appliances with…

Read More »

EIGRP Packet Types / Messages Types and Neighborship Parameters

eigrp-packets

Enhanced Interior Gateway Routing Protocol (EIGRP) is one of the famous routing protocols. It is widely used in networking. In this article, we will discuss types of messages/ packets which is used in the EIGRP Protocol. We will…

Read More »

OSPF Packet Types / Message Types and Neighborship Requirements

ospf-packets-ospf-messages

In this article, we will discuss various OSPF Packet types¬†or Message types¬†that are used by the OSPF Routing Protocol. There are several messages which are used in OSPF in order to share data bits from one router to…

Read More »